RadioActive Studios

RPCS3 is an experimental open-source Sony PlayStation 3 emulator and debugger written in C++, developed with the open-source LLVM Compiler Infrastructure project for  Windows and Linux. RPCS3 not only allows you to play PlayStation games on PC but it also allows you to play them in 1080p, 4K Resolution and it also takes advantage of advanced high end hardware of PC to give higher frame-rates that greatly exceed original PlayStation hardware. RPCS3 is now good enough to emulate some games at full speed but the list of fully compatible games is not very long so  check the official compatibility list before attempting to emulate. System Requirements: Windows 7 64-bit / Linux 64-bit Processor with SSSE3 support Dedicated Graphics Card supporting OpenGL 4.3 or greater Minimum 4GB RAM, 8GB recommended  Software Requirements: Microsoft Visual C++ 2015 Redistributable Microsoft DirectX End-User Runtime PlayStation Firmware (PS3UPDAT.PUP) Installation:

Hello Guys, After two years of smooth game play on my Play Station 3 console, one day I encountered a problem that my ps3 won't go further than System Restore due to some Force shutdown problem. Well it was normal for me because it was often that my I had to force shut down my PS3 and after that It would perform System Restore to Recover some kind of files. But this time I wasn't able to boot into the system the system restore won't complete or It will start again. So, it was stuck in some kind of loop. The point is I can't boot into the my PS System. So, I did some research on the Internet and found out that there could be some bad sectors on my Hard Drive. It's normal to have bad sectors on the hard drive due to system errors and the internet guys told me that only solution to bad sectors is Hard Drive format but I can't afford to lose my save game data and all the other stuff in the Drive. After some more digging I came up with a solution to